Board on board fence overlap

How do you calculate board on board fence?

When constructing a board-on-board fence, subtract the board overlap from the width and divide the result into the fence length. Multiply the number of slats by the height of the fence to find the number of linear feet of slat or picket material you need.

What does board on board fence mean?

What is Board on Board Fence? Board on board fencing is constructed with an overlapping pattern of vertical pickets where every other board is attached to the opposite side of the fence rails, creating a gap in the fence.

Can you put fence boards tight together?

Installing wooden fence boards too tight together: this will cause the boards to warp because when the wood becomes moist it will expand. Make sure to leave a half inch or more in between the boards. Incorrect post spacing: posts should be about every 6 to 8 feet, depending on the type of material used.

Is board on board fence more expensive?

Board on Board fencing costs on average $4 to $7.00 per linear ft to be installed on your property. Board fencing is cheaper than Vinyl fencing and slightly more than a chain-link fence.

How can I make my fence more private?

Here are some strategies for creating more privacy:

  1. Fences. Privacy settings for fences range from private (solid tongue-and-groove or board) to semi-private (slat, picket, spindle or lattice) to rather public (rail). …
  2. Walls. …
  3. Evergreen Hedges. …
  4. Mixed Screen Plantings. …
  5. Lattice. …
  6. Treillage. …
  7. Vertical Gardens. …
  8. Bamboo.
You might be interested:  Build a seating wall

Is it better to nail or screw fence boards?

Nails are faster than screws to install, meaning less labor for you or your builder (which may translate into lower installation cost). … Screws, on the other hand, secure the fence better than nails. They also ensure easier rework should you need to replace a damaged picket.

What is the spacing between fence boards?

When building a solid privacy fence, the fence boards are either butted tightly together, or spaced 3/8 to 1/4 inch apart to allow the wood to expand and contract in wet and dry weather. The board-on-board style of fence is often used as a “good neighbor” fence, since it is equally attractive on both sides.

What does board on board fence look like?

A board on board fence is a fence that consists of central wood posts with wood fencing panels on either side. In other words, board on board fences layer vertical boards on top of each other. If installed correctly, every other board is attached to an opposite side of the fence rails, with small spaces in between.

What are the horizontal boards on a fence called?

Rails, Pickets and Panels

Rails: Rails are the horizontal part of a fence that hold the pickets or panels in place. Many vinyl fences have two rails, one at the top and one at the bottom.

How do I keep my fence board from warping?

Put in back rails about eight inches from the top and bottom of the fence to stop it from warping. If your fence will be higher than 8 feet then you may want to put another rail in the middle. Once you finish building, apply a sealant to the wood. It will slow the drying process so that everything happens more evenly.

You might be interested:  Railroad tie retaining wall

Should a fence touch the ground?

Should the Fence Touch the Ground? In most cases, no fence materials other than your fence posts should touch the ground. Allowing your fence to touch the ground makes yard maintenance more difficult and may increase the speed at which your fence suffers moisture damage, depending on the fence material used.

Leave a Comment

Your email address will not be published. Required fields are marked *